View single post by DB9 | |||||||||||||
Posted: Sun Nov 29th, 2015 09:16 pm |
|
||||||||||||
DB9
![]() |
I just had a look at mine in comparison to yours, the difference is between them that your centre section is on the outside of the tool and mine is on the inside, however this should not make a difference to the operation, where mine pushes upwards as the tool jaws close and lower as the jaws open. If I have got the understanding correct, its seems that the centre section pushes upwards against the clip when clamping it into position to ensure that the clip is seated correctly when compressed together. Hope that makes sense ![]()
|
||||||||||||
|