board_home 

Visit the
UK MOT Testing
Industry Portal


imi training

 Moderated by: Stealth, MOTman, KevG, bimmer
New Topic Reply Printer Friendly
new lay out  Rate Topic 
AuthorPost
 Posted: Thu Jul 5th, 2018 04:48 pm
  PM Quote Reply
1st Post
castrolrob
Trade Member
 

Joined: Sun Sep 10th, 2006
Location: Luton,a Minor Province Of, Bangladesh
Posts: 1322
Status: 
Offline
Mana: 
think the majority of the problem is that most(particularly pre 09) don't read anywhere near their plated limit and whats more never have done but up to this point no one had ever checked,have seen some with all the paperwork/history with identical smoke readings going back a decade or more,failed smoke,nuffing wrong with em except for a government directive.given that all we measure is soot and the pollutants causing the most problems(ie nox etc)are not even tested for by us you gotta admit its pretty laughable.except perhaps for the poor bastards that own em that the gvmnt seem to expect to just go out and buy a more modern vehicle that is:shock:i sincerely doubt that THEY are laughing one little bit:X

Back To Top PM Quote Reply  

 Posted: Wed Jul 4th, 2018 08:17 pm
  PM Quote Reply
2nd Post
Paul S
Member


Joined: Mon Aug 17th, 2015
Location:  
Posts: 224
Status: 
Offline
Mana: 
:shock: effects everyone "This is asset-stripping like you have never known"

https://www.bigissue.com/latest/social-activism/save-the-arches-clapham-north-mot-faces-closure-after-almost-60-years/
Stuff changes for better or worse?... footie aint so bad :)

Back To Top PM Quote Reply

 Posted: Wed Jul 4th, 2018 06:29 pm
  PM Quote Reply
3rd Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
I think the plate is when the system was new and all good working order but when an engine done 60+k and not been looked after I think most will fail on smoke so it will get van drivers too look after there engines more .but time will tell if it will work my fail rate has gone up now since new rfr .:shock:

Back To Top PM Quote Reply  

 Posted: Wed Jul 4th, 2018 06:05 pm
  PM Quote Reply
4th Post
castrolrob
Trade Member
 

Joined: Sun Sep 10th, 2006
Location: Luton,a Minor Province Of, Bangladesh
Posts: 1322
Status: 
Offline
Mana: 
its not massively over is it?also somewhat unusual to have a vivaro that revs!check the basics first,air/fuel filters,is the egr jamming,how old is the oil?stuff like that,if all checks out ok take it out and wring its neck with maybe an injector conditioner or similar poured in first(preferably direct into the fuel filter) and given an hour or twos running to give it a fighting chance of having some sort of effect rather than pouring a bottle in and smoke testing it again instantly and being surprised by it still failing:shock:shame is this reading last year would be a fast pass as in better than normal,this year its a fail:Xto be honest the brake pipes are the main issue(assuming the balljoints don't fall off on his way home!)you say the smoke limit is low for this type of van?most have a plated limit of 0.50 or thereabouts,this ones limit is relatively high.

Back To Top PM Quote Reply

 Posted: Wed Jul 4th, 2018 05:12 pm
  PM Quote Reply
5th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
yes it make good reading how will smoke be repaired its low for type of van

Back To Top PM Quote Reply  

 Posted: Tue Jul 3rd, 2018 05:33 pm
  PM Quote Reply
6th Post
castrolrob
Trade Member
 

Joined: Sun Sep 10th, 2006
Location: Luton,a Minor Province Of, Bangladesh
Posts: 1322
Status: 
Offline
Mana: 
the only improvements ive found are that you don't have to select front/rear for position lamps + 1 less screen to access em and greased brake pipes finally have an advise,look up oy60ukl for details......

Back To Top PM Quote Reply

 Posted: Tue Jul 3rd, 2018 05:12 pm
  PM Quote Reply
7th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
I do agree the system needs a good update to sort it out who ever made the rfr can not of ever mot a car because he would now how hard it is to dam find rfr

Back To Top PM Quote Reply  

 Posted: Fri Jun 29th, 2018 08:01 pm
  PM Quote Reply
8th Post
Paul S
Member


Joined: Mon Aug 17th, 2015
Location:  
Posts: 224
Status: 
Offline
Mana: 
this entire system should be listed under the nuisance section :)....:shock: Categories Body, chassis, structure Passenger compartment 6.2.1 (c) (ii) & (i) shud also be under Fuel system & Exhaust system Noise, emissions and leaks.

Back To Top PM Quote Reply

 Posted: Wed Jun 27th, 2018 09:58 am
  PM Quote Reply
9th Post
castrolrob
Trade Member
 

Joined: Sun Sep 10th, 2006
Location: Luton,a Minor Province Of, Bangladesh
Posts: 1322
Status: 
Offline
Mana: 
yup and brake performance rfrs shouldn't require going thru 6 screens to access,headlamp beam pattern shud be a simple accessible failure,track rods/balljoints shouldn't be listed as"other items"link bar balljoints/covers etc shud all be on the same screen instead of listed separately before you ever get to a failure screen,this entire system should be listed under the nuisance section:shock:

Back To Top PM Quote Reply  

 Posted: Tue Jun 26th, 2018 09:04 pm
  PM Quote Reply
10th Post
Paul S
Member


Joined: Mon Aug 17th, 2015
Location:  
Posts: 224
Status: 
Offline
Mana: 
Fuel system & Exhaust system shud be under Noise, emissions and leaks.

Back To Top PM Quote Reply

 Posted: Fri Jun 22nd, 2018 05:14 pm
  PM Quote Reply
11th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
ok thanks for that will have a look next week now

Back To Top PM Quote Reply  

 Posted: Wed Jun 20th, 2018 06:46 pm
  PM Quote Reply
12th Post
martins
Administrator


Joined: Sat May 27th, 2006
Location: London, United Kingdom
Posts: 317
Status: 
Offline
Mana: 
5.3.4 Suspension joints, pins and bushes?

Back To Top PM Quote Reply

 Posted: Wed Jun 20th, 2018 06:35 pm
  PM Quote Reply
13th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
well been getting me head round the new layout stil get stuck on items and have to use the search box but can not find macpherson strut top bearing is it me or has it goen for good :?

Back To Top PM Quote Reply  

 Posted: Sat Nov 5th, 2016 07:16 pm
  PM Quote Reply
14th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
I total agree its now made me slower on it because I got to get to grips again .

Back To Top PM Quote Reply

 Posted: Sat Nov 5th, 2016 06:18 pm
  PM Quote Reply
15th Post
castrolrob
Trade Member
 

Joined: Sun Sep 10th, 2006
Location: Luton,a Minor Province Of, Bangladesh
Posts: 1322
Status: 
Offline
Mana: 
used it for the first time today,cant see what the advantages are if any,just gotta learn to navigate round a new setup after being used to the old one,combined with todays website f***up it made for an interesting day.what is it supposed to be improving?anyone?

Back To Top PM Quote Reply  

 Posted: Fri Nov 4th, 2016 06:42 pm
  PM Quote Reply
16th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
well today was my first time I used the new layout its ok does take time to read screen and open more boxes we will have to get use to and I expect it will change again..:P

Back To Top PM Quote Reply

 Posted: Sat Oct 29th, 2016 05:01 pm
  PM Quote Reply
17th Post
castrolrob
Trade Member
 

Joined: Sun Sep 10th, 2006
Location: Luton,a Minor Province Of, Bangladesh
Posts: 1322
Status: 
Offline
Mana: 
no surprise,cant take fails/advises most of the time either:shock:

Back To Top PM Quote Reply  

 Posted: Thu Oct 27th, 2016 07:19 pm
  PM Quote Reply
18th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
it went wrong system could not take the update :D

Back To Top PM Quote Reply

 Posted: Thu Oct 27th, 2016 03:33 pm
  PM Quote Reply
19th Post
chrisdms
Member
 

Joined: Fri Oct 24th, 2008
Location: United Kingdom
Posts: 5
Status: 
Offline
Mana: 
Whoops.... didn't happen.

Back To Top PM Quote Reply  

 Posted: Wed Oct 26th, 2016 04:21 pm
  PM Quote Reply
20th Post
supertom
Trade Member
 

Joined: Tue Sep 16th, 2008
Location: Westmidlands, United Kingdom
Posts: 152
Status: 
Offline
Mana: 
well guys and girls we get the new layout tomorrow lets all hope it dam works got a lot to do :?

Back To Top PM Quote Reply

Current time is 04:11 pm  
MOT Forum - The MOT Testing Forum for the UK MOT Testing Industry > Trade Category (MOT Trade Discussions) > Computerisation Forum - Problem with the computer? try here | MOT Forum > new lay out Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems